Garage Door Installation in Davie - Written Price, Installed in One Visit

Trusted Garage Door Installation for Davie Homeowners

A new garage door installation in Davie typically costs between $700 and $2,200, and the work takes roughly four to six hours for a standard double door when the existing framing is sound. At Servo Garage Doors Davie, we’ve handled installations across town since 2015, from the ranch-style homes off Flamingo Road to newer builds in the Shenandoah section, and every one has closed the same way: with a written scope, a flat price agreed before any work began, and a photo record of what we found and what we installed.

If your current door is sagging, banded with rust at the bottom panel, or simply louder than it was a year ago, replacing it before the tracks go out of alignment can save you a second service call. Marcus Deller, who runs Servo Garage Doors Davie, answers the phone personally when he’s in the office. You can also reach the team around the clock at (754) 704-3976.

Call (754) 704-3976

What Our Garage Door Installation Service Includes

Every installation starts with an inspection of the opening, the surrounding framing, and the condition of the existing tracks and hardware. We do not quote a door until we’ve measured it. That measurement, the door model, the hardware list, and the labor are all written into a single flat price before anything is ordered. The customer signs off on that number before we touch the garage. That’s Clause 1 of The Haven Standard, the operating rules our independently owned and operated business has worked under since Marcus brought the brand to Davie.

New Door Installation

A full new door installation means removing the old door and its horizontal and vertical tracks, inspecting the mounting points where the track brackets attach to the wall and ceiling, and replacing any lag screws or anchors that have worked loose over years of vibration. We then set the new door in place, level the bottom panel, balance the spring system to the weight of the new door, and run a complete travel and force check on the opener. In Davie, where summer storms can push wind through the garage opening, we pay particular attention to reinforcing the track mounting and the struts on the top panel to prevent bowing during high gusts.

Single Car Door

A single car door spans roughly 8 feet wide by 7 feet high and is common in the older sections of Davie around Orange Drive and in many of the early-2000s townhouse developments near Nova Southeastern University. Installation usually takes three to four hours, provided the framework is intact. The benefit of a single door is straightforward: the lighter panel means a smaller torsion spring, less strain on the opener, and lower long-term wear on hinges and rollers. We always size the spring to the exact weight of the specific door model, not a generic range.

Double Car Door

A double door, typically 16 feet wide, is the standard on most newer single-family homes in Davie and the surrounding Southwest Broward area, including neighborhoods off Stirling Road and University Drive. These doors weigh significantly more, usually between 250 and 400 pounds depending on the material and insulation, which means the torsion spring system and cable assemblies carry real load. We photograph the spring pads and cable drums before and after installation, and we include that documentation with every finished job, per Clause 4 of The Haven Standard. If the door ever needs a warranty call or an adjustment, you have the before and after record in hand.

Custom Garage Door

When a standard 7-foot or 8-foot door won’t fit because the opening was framed differently or the homeowner wants a specific look, we order a custom door built to the measured dimensions and panel configuration. In Davie, this comes up often with older ranch homes on larger lots where garages were originally built for a single car and later expanded, or where a carport was enclosed. Custom work carries a longer lead time, typically two to four weeks for manufacturing, and the price is quoted once the manufacturer confirms the build. We do not ask for a deposit until the written scope is signed and the date is set.

Steel Doors

Steel doors are the most common replacement choice in Davie because they hold up well to Florida humidity without the warping or swelling that affects solid wood. They come in multiple layers, from a single-layer panel with no insulation to a triple-layer door with a steel back and a polyurethane core, and that construction difference changes both the price and the way the door behaves. We explain the R-value of each layer so the homeowner understands what they are paying for, not just what it looks like. A triple-layer steel door also cuts down the heat that transfers into a west-facing garage in July, which matters if the garage sits under a bedroom.

Wood Doors

Solid wood and wood-overlay doors are a niche choice in Davie, usually for homes with a specific architectural character or an HOA requirement in one of the gated communities. They are heavier than steel, which means the spring system and opener both need to be sized up, and they require more maintenance over time, particularly in South Florida’s wet season. We install them correctly, but we also tell the homeowner plainly what the finish will need in year three, year five, and year ten. No one should buy a wood door in this climate without knowing the upkeep cost, and we would rather lose a sale than leave that unsaid.

Brands We Service for Garage Door Installation

We install and service all eight major brands we stock parts for: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. With Amarr doors, our team has probably installed more of their Classica collection in Davie than any other single style, and we know the spring sizing for their steel-back models without having to call a rep. The photo record of an Amarr install always includes the hinge stamps and the spring tag, so the homeowner can identify the part number years later without digging through a receipt.

We also do a steady number of Clopay and Wayne Dalton installations. Clopay’s polyurethane-core doors are heavily represented in Davie’s newer subdivisions, and Wayne Dalton’s TorqueMaster spring system is common in townhome garages from the mid-2000s, including a number of the communities east of Davie Road. Whether your door is a Craftsman unit from a big-box install or an older Raynor model, our technicians know the mounting pattern and the balance requirements, and we carry the matching hardware on the truck. No other make throws us; if you can open it, we can replace it.

Before

After

Signs You Need Garage Door Installation Right Now

• The door no longer sits square in the opening. When you stand outside and look at the gap between the bottom panel and the slab, it is wider on one side. That means the door has shifted, usually because the hinges or the track mounts are worn. A door that sits crooked eventually binds against the track and either refuses to close or pops a cable.
• The panels are showing rust, delamination, or cracks at the stiles. Steel doors rust from the inside out in Florida’s humidity, particularly along the bottom panel where standing water collects after a storm. Once the panel skin separates from the core, the door loses structural stiffness and becomes dangerous to operate. A replacement panel is sometimes possible, but on a 12- to 15-year-old door, the new door often costs less than repeated panel work.
• The door shakes or shudders on the way up and down. Shuddering is never just a “noisy door.” It means the rollers are worn, the hinges have play, or the spring has lost tension on one side. If the problem is in the panels themselves, replacing the rollers and springs alone won’t fix it. We photograph the specific components causing the shake and show the customer what failed before recommending a full install.
• You are replacing the spring or opener for the third time in the life of the door. A well-installed door and a correctly sized spring should last a long time. If you’ve already had two spring replacements in the last eight years, the door weight and the hardware may be mismatched. At that point, installing a new door with a matched spring system and new tracks is usually cheaper over the next decade than patching the old one.
• The door is wood and has not been refinished in the last three years. We see this around Davie’s older homes: a solid wood door that has swelled at the bottom, cracked at the joints, and pulled away from the weather stripping. The door is heavy, the paint is flaking, and the homeowner is nursing it along. It may keep working for another year or two, but it’s working against the hardware, and no new opener or spring will change that.

None of these signs alone proves you need a new door. What they do prove is that something has degraded far enough to affect the rest of the system. The fastest way to know is to have a technician measure the door weight, check the track alignment, and photograph the failing components. We do that on every visit, and we hand you the record before any replacement is quoted.

Our Garage Door Installation Process - Step by Step

1. 1
   Measure and inspect the opening, the framing, and the existing hardware. We check the header for sag, the jamb seals for rot, and the track mounting points for movement. If the framing needs work, that is written into the scope and the flat price before we go further. The customer sees the exact condition of their opening, with photos, before we propose a door for it.
2. 2
   A written quote with a single flat price, itemized scope, and no open-ended labor line. This is Clause 1 of The Haven Standard, and we don’t waive it for any job. The quote lists the door model, panel configuration, insulation value, hardware, haul-away of the old door, and the labor. The customer signs the quote. Work starts only after that signature, and the price cannot change unless the customer asks for something outside the written scope.
3. 3
   Remove the old door and hardware, and inspect what is underneath. Once the old door is down, we check the slab for level, the mounting surfaces for rot, and the opener rail for wear. We photograph what we find. If there is a problem we could not see during the initial inspection, we stop, show the customer the photo, and agree on a written change order before proceeding. Nothing gets done on a “trust us” basis.
4. 4
   Install and balance the new door, then run the full test cycle. The new door goes in, the torsion spring is wound to the exact balance point for the door’s weight, and the opener’s travel and force settings are checked against the actual door, not the factory defaults. We run the door through multiple full open and close cycles, check the safety reversal, and confirm the door seals evenly against the slab and side jambs.
5. 5
   Walk the customer through the finished job and deliver the documentation. You receive the photo record showing the old door as found, the opening after removal, the new door installed, and the ID tag or stamp on the spring and rollers. You also receive the signed scope and the warranty document. If anything is not right, the 365-Day Done Right Promise applies, and we make it right. That promise is in writing, on our terms page, not just in a handshake.

How Much Does Garage Door Installation Cost in Davie?

Garage Door Installation Near Davie - Our Service Area

Servo Garage Doors Davie works throughout the town and across the surrounding Southwest Broward cities. Most installations in Davie proper, including the neighborhoods west of University Drive and the older sections near the Bergeron Rodeo Grounds, can be scheduled within the same week. We also serve Cooper City, where the townhome developments off Griffin Road keep us busy, and Plantation, where the older single-family stock along Broward Boulevard often needs full track replacement along with a new door. If you live in Pembroke Pines, Sunrise, Weston, Dania Beach, Miramar, Hollywood, Miami Gardens, Fort Lauderdale, or Hallandale Beach, we are a short drive away and can quote the job the same week. We also offer Garage Door Installation in Cooper City and Garage Door Installation in Plantation for homeowners in those cities who prefer a page that speaks directly to their area.

Frequently Asked Questions - Garage Door Installation in Davie

Schedule Your Garage Door Installation Service in Davie Today

If you are in Davie and need a new garage door, call Servo Garage Doors Davie at (754) 704-3976 for a free on-site measurement and a written flat-price quote. The estimate is no-obligation, the scope is written before any work begins, and the 24/7 phone line is answered by a real person. Back to our home page for the full list of services.

Written by Marcus Deller, Owner at Servo Garage Doors Davie, independently owned and operated under The Haven Standard since 2015.